Shure AD4Q-DC Axient 4-Channel Digital Wireless Receiver, ADX DC Power Module

Share

This Shure AD4Q-DC Axient Digital 4-Channel Receiver is Model AD4Q-DC=A with a frequency range of 470 - 636 MHz

The Shure AD4Q-DC Axient Digital 4-Channel Receiver sets a new standard in transparent digital audio and maximum spectral efficiency. Groundbreaking performance features include wide tuning, low latency, High Density (HD) mode, and Quadversity™, ensuring solid performance in the most challenging RF environments. Networked control, AES3 + AES67 + Dante™ and signal routing options bring a new level of management and flexibility to your entire workflow. Compatible with all Axient Digital transmitters.

Close up image is available here.

Shure AD4Q-DC Axient Digital 4-Channel Receiver - Features:

• DC Power Module supports backup power sources and remote operation
• Wide tuning range up to 184MHz
• True digital diversity reception per channel for drop-out resistance
• Networked control with Wireless Workbench® and ShurePlus™ Channels app
• Quadversity™ mode for extended antenna coverage and improved RF signal-to-noise
• Front panel headphone jack enables Dante Cue and Dante Browse monitoring
• Configurable Ethernet switch for redundant Dante digital output
• Switchable XLR/AES3 outputs
• Channel Quality meter displays RF signal-to-noise
• Locking AC connectors
• DC module supports redundant power

• Audio Output:
  • Gain Adjustment Range: -18 to +42 dB in 1 dB steps (plus Mute setting)
  • Configuration:
    • 1/4" (6.35 mm): Transformer-Coupled Balanced (Tip=audio, Ring=no audio, Sleeve=ground)
    • XLR: Transformer-Coupled Balanced (1=ground, 2=audio +, 3=audio -)
  • Impedance, Typical, XLR Line Out: 100 Ω
  • Full Scale Output, 200 kΩ load:
    • 1/4" (6.35 mm): +8 dBV
    • XLR (LINE setting): +18 dBV
    • XLR (MIC setting): -12 dBV
  • Mic/Line Switch: 30 dB pad
  • Phantom Power Protection: Yes
• Networking:
  • Network Interface: 10/100 Mbps, 1 Gbps, Dante Digital Audio
  • Network Addressing Capability: DHCP or Manual IP address
  • Maximum Cable Length: 328 ft | 100 m
• Cascade Output:
  • Connector Type: BNC (for connection of one additional receiver in the same band)
  • Configuration: Unbalanced, passive
  • Impedance: 50 Ω
  • Insertion Loss: 0 dB, typical
• RF Input:
  • Spurious Rejection: >80 dB, typical
  • Connector Type: BNC
  • Impedance: 50 Ω
  • Bias Voltage: 12 - 13.5 VDC, 150 mA maximium, per antenna switchable on/off
  • Model AD4Q-DC=A RF Carrier Frequency Range: 470 - 636 MHz
• General:
  • Housing: Steel; extruded aluminum
  • Power Requirements: 100 to 240 VAC, 50–60 Hz, 0.68 A max
  • Thermal Dissipation: Maximum: 23 W (78 BTU/hr); Idle: 15 W (6
  • DC Input Voltage Range: 10.9 - 14.8 V DC
  • Maximum DC Input Current: 4.0 A
  • Protection Modes: Overvoltage, Undervoltage, Reverse Polarity
  • 4-Pin XLR: Pin 1: Negative; Pin 2: No Connection; Pin 3: No Connection; Pin 4: Positive
  • Dimensions (H x W x D): 1.7 × 19.0 × 13.1 in | 44 x 483 x 333 mm
  • Weight 10.6 lb | 4.8 kg, without antennas